York-Raceway.Com

Any recomendations local to me in Cumbria for V8 machining work... ie a rebore.
Preferably somewhere i can drive to in under 2 hours. ie within 160 miles

I used North East engines in Darlington on the recomendation of Mark Flavell. They seem to have done a good job.
The problem with the race engine shops is that at this time of year they are too busy and put the bigger money jobs through first which always seems to turn into a long wait.

w.drakes in bradford do a good job,i have used them for over twenty years and never had a problem,they have just done a load of machine work on daz oxleys 452 mopar and they also do a lot of work for dave billadeau .they also sponsor york (or did) so it makes sense to give a bit back.

They are an associate sponsor of American Super/Stock & I too can recommend them, They did all the machine work on my SBF.

Drakes quoted £235 for a +20 rebore.
All i need now is to know i have another job to go to in March then i can get the ball rolling and buy some pistons and rings.

Does anyone know of Lancaster Engines in Lancaster or Redmans engine centre in Fleetwood?

Used North East Engine Services in Darlo since I trashed the motor in my Polo years ago!! , Know Mike Flowers very well and have NEVER had a problem with anything!! Highly recomended

Ive been recommended Pauk Gardner Race engines.... http://paulgardnerengineering.com/

Might be easier for me as hes near Forton which is less than an hour from home